ALL RETURN SERVICE ON NFA SHIPMENTS WILL REQUIRE A SIGNATURE
RETURN SHIPMENT COST IS INCLUDED IN PRICING
PLEASE PUT YOUR TRUST INFORMATION IN EITHER THE COMMENTS OR THE ENGRAVING CODE BOX
Please send us your lower either stripped or without the stock/buffer tube attached.
Taping off the location of the engraving is encouraged
Turn Around is VERY quick on these because very little paperwork is required if they are shipped out the same day they are delivered
Discounts available by volume . Please call 731-334-5106 or email us through the "Contact Us" portion of the page
Choose your engraving location. If not listed, please state the location in the comments
Submit the Engraving Information. It will be engraved as it is typed. All cap engravings will be 2mm high, caps w/lower case will be 2.5mm high to make sure the height of the lower case letters covers ATF standards for engraving
Tape off the area you want engraved with masking/painters tape (completely optional but encouraged)
Pack with care and send to the address below.
Please Send Your Item(s) to:
Tennessee Arms Company
517A Lake Road
Dyersburg, Tn 38024
Return Shipments will Require a Signature
Does my shipment need to be returned to a FFL for Transfer? No, this is considered a repair by the ATF and is treated as if you were sending your firearm to a gunsmith. The shipment will be returned to you with a signature requirement
Can I send my suppressor tube? Yes and No. If your tax stamp hasn't been approved yet, the tube is considered to be just that, a tube. Once a stamp is approved, the tube is considered to be part of a suppressor assembly and cannot be received by Tennessee Arms Company. We are looking into getting an SOT because of this.
Can you engrave to the required depth? Yes, our fiber laser can hit the .003 depth on metal and our CO2 laser can hit the depth on polymer frames. We have engraved everything from Nylon to Titanium .
Can I do multiple engravings on one order? Yes, but that would be a call in order. Please call 731-334-5106 for bulk pricing.
Why does this cost more than a bigger, magwell engraving...it's just text? This is a common question, and easy to answer. NFA engravings require us to hit a depth of .003 inches. To do this, multiple passes are needed with the laser. Where a magwell engraving takes one pass from 2 angles, the NFA engravings take 25 passes from 2 angles . It is a more time consuming process which calls for a slightly higher cost.
Can I ship a completed 80% receiver to have engraved? No, we CANNOT receive completed, finished 80% receivers.
Any other questions can be answered through the CONTACT US portion of the page.